A Notch is regarded as an orifice with water level below its upper edge. Notch is made of a metallic plate and its use is to measure the discharge of liquids. These are used for measuring the flow of water from a vessel or tank with no pressure flow.

A trapezoidal notch is a combination of a rectangular notch and two triangular notches as shown in figure. It is, thus obvious that the discharge over such a notch will be the sum of the discharge over the rectangular and triangular notches.


To calibrate the given trapezoidal notch by establishing the relationship between the  flow rate and the head over notches.


Watch this Video to know more about Orifice meter

Also Check Out – Consistency of Concrete by Slump Cone

Thanks for visiting us…

To calibrate the given Trapezoidal Notch – Fluid Practical
Tagged on:             

Leave a Reply

Your email address will not be published. Required fields are marked *